PRÜF MOVER SIGHT - SAGE

This sight is everything it’s hyped up to be honestly. Feels pretty rugged especially for how light it is. The in hand feel of every part feels quality as it should. The angled rail truly does give you extra range. With my current arrow setup, I can dial it out 40 yards further than I could with a standard slider sight (pruf goes out to 150yds before vane clearance becomes an issue). Pin brightness seems to be some people’s concern, it was for me, but these pins are often too bright honestly. I find myself closing off the sun shield halfway for most of the day.

Onto the small gripes I have which kept me from leaving 5 stars, two of the three are bridge lock specific. Firstly the biggest issue, for whatever reason while using bridge lock the scope housing needs to sit partially off the main rail or you’ll have to part ways with the built in zero stop. It doesn’t effect any part of how the sight functions however, it’s completely an aesthetic thing and could have been avoided by adding 1” to the bottom of the rail. Gripe number two is the bridge lock mount itself. There’s only one spot that’ll accept the bridge lock screw meaning there’s only one distance you can put the sight away from the riser. Good luck torque tuning if you have a QAD integrate paired on with it. Third gripe is horizontal pin specific and isn’t a huge deal, no micro adjust horizontal pins. It’s kind of a pain to move the pins where you need em and a micro adjust addition would save half an hour on sight in.

All in all, I would definitely purchase this sight again. I just found some things that appear to have been overlooked on the Mathew’s side of things.